Water Heater Hookups


The hot water heater is a crucial appliance for your home since it provides hot water that is necessary for washing and cleaning clothes. As the heater continues to age, the efficiency to energy reduces and the internal tanks start corroding. The corrosion may cause leaks, and in other cases, causes it to burst and flood the home. The installation of a novel heater on time will prevent this from taking place. The process of installing the heater involves basic electric and plumbing skills.

Water heater hookups are among the commonest home repair tasks to carry out in the home. Nevertheless, in case you do not know what you are doing, or do not know the leading thing about water heaters, then you could find yourself in hot water. However, installing a heater is an easier thing to lean. All you need to do is to make sure that you are reading directions before starting, therefore, do not get it over your head even before starting. The most undesirable thing is knowing that you are not able to do it and then get stuck without hot water.

When doing water heater hookups, test the wiring for the heater by touching probes of the volt tester against bare wire tips. When you get a reading, get to the main panel and switch off the right circuit. The circuit has to be turned off before removing the old heater, but double-checking the volt line powering the heater will save your life.

Move your water heater to position with the help of a hand truck. Get an assistant to help you to move the heater in case you are struggling to do it.

Put a lever on the water heater. Put shims under the heater to level it when necessary.

Wrap the tape around the threads on the pipe that stick on top of the heater. The tape is crucial for providing a tight seal that prevents leakages from taking place.

Connect your water heater to pipes that carry cold water to the tank and get hot water from the tank with the help of the available PEX tubing. Utilize the red PEX tube to connect your hot water outlet on top the heater to the line carrying hot water to faucets of the home and blue PEX tubing for connecting cold water inlets to the water heater to line carrying water to the heater.

Close your drain valve found on the water heater bottom when open. Open all taps of hot water in the home.

Open your valve found on the main line which feeds cold water to the water heater. Allow water to fill your tank, flow out via the hot line, and through spigots in the home. Allow water to get through spigots for a minute to get air trapped in the lines, and turn the taps off.

For perfect water heater hookups, eliminate the plate found on top of the heater concealing the wiring. Pull the wires out of the tank. Strip one inch of the insulation from the wire by use of wire strippers.

Punch the knockout hole that is next to your wires by tapping with the help of the screwdriver and hammer. The connector of the cable will cover the knockout hole and has a screw for locking electrical cables in place, which prevents it from sliding, which may damage the insulation.

Insert a cable which runs to the electrical panel via the electrical conduit. Slide the cable end via the cable connector into the top of the heater until when the wire gets connected to wires in the heater. Insert an end of your conduit in the connector and tighten the screw on the connector.

While still doing water heater hookups, you will have to twist the red wire coming from the heater to red wire coming from the cable with the help of pliers. Place the plastic twist cap on the wires and twist then severally. Connect black wires together with the help of the same method. Wrap the ground wire on the green ground screw of the water heater and then tighten the screw.

Put the wiring on top of the heater. Put the metal cover on the water to cover your wiring. Set your thermostat found on the front of the heater at the required temperature. Turn the power on from the main electrical panel.

Here is a list of our services you can get at Best AC Repair Services Company in West Palm Beach:

1) Free AC Estimates
2) Air Quality Testing and Control
3) 24 Hour Emergency Air Conditioning Repair
4) 24/7 repair service
5) Residential Air Conditioning
6) Residential HVAC Unit Installations
7) Residential Maintenance
8) Commercial Air Conditioning
9) Commercial Maintenance
10) Commercial HVAC Unit Installations
11) New AC System Installations
12) Air Conditioning Unit Replacement
13) AC Troubleshooting
14) Heating Repair
15) Electrical Repair and Maintenance
16) AC Tune Ups
17) Monthly AC Maintenance
18) Preventative AC Maintenance
19) UV Light Air Quality Services
20) Water Heater Hookups
21) AC Precision Tune Up
22) Air Conditioning Ductwork
23) Piecework and Subcontracting
24) UV Light Installation
25) Freezing Issues
26) Eco-Friendly UV Lights
27) Thermostat Issues
28) Duct Cleaning
29) UV Germicidal Lights
30) UV Lighting AC Systems
31) HVAC UV Lights
32) HVAC Repairs
33) Air Sterilization UV Lights
34) HVAC UV Light Installation

Request for a free quote from our AC Repair Services company now!

We also service all cities throughout Palm Beach County! Below are a list of cities where we offer our AC Repair Services:

  1. Boca Raton
  2. Palm Beach
  3. All cities in the Palm Beach County area. Just call and ask!


Call Now ButtonCall Us: (561) 232-6366